Skip to main content
All CollectionsFingerprint readerRegistration from the fingerprint reader to the object
Registration of working time to the object from the fingerprint reader
Registration of working time to the object from the fingerprint reader

Instructions on how an employee can use the fingerprint reader to register working hours for a specific object

Yulia Puplaka avatar
Written by Yulia Puplaka
Updated over a week ago

Using the fingerprint reader, it is possible to register the working time for the object in two ways:

  1. Manually, i.e. using the object's PIN code

  2. Automatically, i.e. by linking the device to the object

In order to register working time for an object manually using the object's PIN code, proceed as follows:

a) Press the " JobCode (arrow up) " key on the device
b) Place your finger on the sensor
c) Enter the object's PIN code on the keyboard d) Press the " OK "
key 1x e) Repeat the previous points (a) to end the working time

The PIN codes of the objects can be found in the "Setting" - "Objects" list:

It makes sense to link the device to an object if each object has a different reader and you want to make an object-based calculation. After pairing, an object is automatically added to each working time from the device on the time sheet. To link a device to an object, proceed as follows:

a) Open "Gear Wheel" - "Objects" in the software

b) Select the object to which you want to link the device and click on the "Edit" button

c) Select the "Bound devices" module in the opened window

d) Drag the required device to the right "Bound" devices column

e) Save changes

f) When recording working time from a device, it is automatically linked to the object to which the device is connected

Did this answer your question?